DSM 7.2 pe HP Microserver Gen 8

F9 -> RBSU
In RBSU:
- System Options -> Serial Options -> Virtual Serial Port: Disabled
	 -> Embedded NICs -> NIC 1 Boot Options: Disabled
	 -> NUMLOCK Power-On State: On
	 -> SATA Controller Options -> Embedded SATA Configuration: Enable SATA AHCI Support
- Power Management Options -> HP Power Regulator: OS Control Mode
	 -> Advanced Power Management Options -> Intel QPI Link Power Management: Enabled
				 -> Minimum Processor Idle Power Core State: C6 State
				 -> Minimum Processor Idle Power Package State: Package C6 (retention) State
				 -> Maximum Memory Bus Frequency: Auto
				 -> Memory Interleaving: Full Interleaving
				 -> PCI-E Gen 3 Control (For Select Devices) -> PCI-E Slot 1: Enabled
				 -> Maximum PCI Express Speed: Maximum Supported
				 -> Dynamic Power Savings Mode Response: Fast
				 -> Collaborative Power Control: Enabled
				 -> DIMM Voltage Preference: Optimized for Performance
- Date and Time: set the correct time and date
- BIOS Serial Console & EMS -> BIOS Serial Console Port: Enabled
- Advanced Options -> Advanced System ROM Options -> NMI Debug Button -> Disabled
				 -> Virtual Install Disk -> Disabled
				 -> Power-On Logo -> Enabled
ESC, confirmati cu F10, apoi apasati iar F9 -> RBSU
- Systen Options -> SATA Controller Options -> Drive Write Cache: Enabled
- Standard Boot Order (IPL) IPL:1 Hard Drive C: (See Boot Controller Order)
	 IPL:2 USB Drive Key (C:)
	 IPL:3 CD-ROM
	 IPL:4 Floppy Drive (A:)
- System Default Options -> User Default Options -> Save User Defaults -> Yes, Save
Begin Installation OS