Seagate FreeAgent Pro - 500GB - se blocheaza

Il am de ceva ani, este incarcat cca. 45% cu muzica, foto si filmulete cu familia.
De cateva zile, doar cand ascult muzica, se blocheaza.
Asta inseamna ca in mijlocul unui fisier audio cu muzica se intrerupe si lista afisata cu continutul folderului se afiseaza in culoare rosu.
Daca incerc sa reiau, face play cateva secunde si iarasi se blocheaza.
Daca deschid continutul unui folder il arata ca fiind gol.
Nu mai raspunde la Safely Remove, asa ca singura cale este sa-l deconectez de la alimentare (are alimentare separata) si din conexiunea cu cablul usb.
Dupa reconectare functioneaza o vreme, insa iarasi cade in "pacat".
Am incercat reluarea de play exact din locul in care s-a blocat si a rulat perect. Este aleator, prin urmare.

Recomandati-mi un soft sa-l caut de bube.
Am copiat tot de pe el pe o partitie libera din computer.
Daca o fi cazul, sa incerc sa-l formatez?

Multumesc.


PS - A fost cumparat de nou si a venit cu un soft Seagate dedicat, care are un Run Drive Diagnostics. Dupa rulare arata in final ca este sanatos tun!?

Edited by addumi, 09 November 2017 - 19:51.

HDTune !

HdTune, HDD Sentinel. Problema nu e neaparat din el, poate fi si din alimentare sau din cablul USB!

Corect. Am inlocuit cablul usb cu unul nou insa a aparut destul de repede aceeasi problema.
Sa fie ceva cu porturile usb ale desktop-ului?
De regula il conectez pe porturile din fata. Asa am facut mereu pana acum.

Pus "Sentinel".
Ceva nu se pupa, clar. HDD -ul din calculator are doar 100 de zile de power on time mai multe decat acest HDD extern, ceea ce in realitate nu este adevarat.
Nu stiu cum functioneaza softul lui Sentinel, dar nu este asa....

Intr-adevar zice ca sta la 46% cu "sanatatea" dar cica este acceptabil. In calculator am 100%.

Edited by addumi, 09 November 2017 - 20:18.

La 46% health in HDDSentinel deja te uiti la altul. O sa il strici de tot daca mai continui asa.

N-ar strica sa incerci cu porturile usb din spate, dar la 46% viata problema clar nu e din porturi. La S.M.A.R.T. cum sta? Ne poti pune o poza?
100 zile de power on time = 2400 de ore de functionare. HDD Sentinel ia aceste informatii din atributele S.M.A.R.T. ale drive-ului. Si cu HDtune poti vedea PowerOnTime.

"Hard Disk Sentinel Help - Power on time
Hard disk power on time can be determined by examining the #9 "Power on time count" S.M.A.R.T. attribute of the hard disk. This value is supported by most modern IDE and S-ATA hard disks.
The raw value of this attribute is constantly increasing when the hard disk is under power (running, but not neccessarily performing a read or write operation). The unit of the time depends on the manufacturer. It can be hours (the value is increased once per every hour), minutes or half-minutes. Different units are also possible and two hard disks from the same manufacturer may not have same time units.
After installation, Hard Disk Sentinel starts examining this attribute. It checks the elapsed time between two consecutive increases of the raw value of this attribute. During this test, an estimated power on time value is displayed (with grey color) and it may not be accurate. This test can run up to 20 minutes. If the user closes the application during the test, it will be automatically restarted on the next launch of Hard Disk Sentinel until it can determine the unit of time used on all hard disks. After successful measure, the unit is saved and it will be used automatically later. This measurement has no effect on the performance of the hard disk or the computer.
After the measurement (or if it is not required) the exact, accurate power on time value is displayed (with black color) and the "estimated value" text is not displayed. If the displayed value seems to be incorrect (too low or high), the "Repeat Test" button can be used.
When the measurement completed, it is recommended to send a test report. The received reports help in further development and it is possible that in a later version the exact power on time count will be displayed from the first time (without the need of the measurement).
The value displayed next to the Power on time indicates the total time the drive was running (powered). Idle time (when there was no read or write operation) also increases this value but standby time does not increase this time. One displayed day means 24 hours. For example, a two years old hard disk which is used 12 hours every day will show the same "power on time" as a one year old hard disk which is used in 24/7 mode (like a 3 years old hard disk working 8 hours every day).
Note: the power on time display may not be correct on some models."

Edited by Cojocel, 09 November 2017 - 20:49.

Daca tot am ajuns la aceasta problema, va rog recomandati-mi un HDD extern (macim 1TB - clar nu am nevoie de mai mult), dar care sa iab alimentare separata si conectare prin USB, asa cum a fost acesta.
Multumesc.

Atasez printscreen cu SMART din Sentinel.