Lexmark X1190

scanerul X1190 se poate folosi, teoretic, prin sane-backend (baza de drivere ale prof-ului de scanare) updatat. Practic, capul de citire o ia invers. (ma refer la sane-backends-1.0.17)

http://www.sane-proj...-lexmark.5.html

Nu mai zic ca n-am NICI reusit s-o fac sa printeze (cu driverul pt. z600). Acu' deja s-a uscat gunoiu'...

A invata linux nu inseamna sa le sti pe toate si sa faci pe desteptul cand apare un afon ce-ti cere ajutorul.

Are cineva rabdare sa ma ajute sa rezolv problema cu lexmarkul ?

Am testat si eu Se pare ca merge sa listeze cu driveru de z600
referitor la scaner se pare ca il vede ok e suportat de backend dar inca nu am gasit o solutie viabila opt a-l folosi
Pt a instala imprimanta urmariti instructunide de aici http://lists.freesta...004/002651.html

bash-3.1# sane-find-scanner

  # sane-find-scanner will now attempt to detect your scanner. If the
  # result is different from what you expected, first make sure your
  # scanner is powered up and properly connected to your computer.

  # No SCSI scanners found. If you expected something different, make sure that
  # you have loaded a kernel SCSI driver for your SCSI adapter.

found USB scanner (vendor=0x043d, product=0x007c, chip=rts8858c) at libusb:001:007
  # Your USB scanner was (probably) detected. It may or may not be supported by
  # SANE. Try scanimage -L and read the backend's manpage.

  # Not checking for parallel port scanners.

  # Most Scanners connected to the parallel port or other proprietary ports
  # can't be detected by this program.
Daca reuseste vreunu ceva cu scaneru da-ti un beep

apropo secventa (vendor=0x043d, product=0x007c, chip=rts8858c) o gasesc si in fisierul lexmark.conf din /etc/sane.d/  mai putin chipu

alentin, on Jul 15 2006, 23:35, said:

  1.   Se deschide o consola in directorul unde ai "CJLZ600LE-CUPS-1.0-1.TAR.gz"
       tar xvfz CJLZ600LE-CUPS-1.0-1.TAR.gz
        tail -n +143 z600cups-1.0-1.gz.sh > install.tar.gz
       tar xvfz  install.tar.gz
   se instaleaza  arhiva  
       z600cups-1.0-1.i386.rpm si  z600llpddk-2.0-1.i386.rpm
     ./install
    2.     in consola se tasteaza
  pkgtool  
apoi se bifeaza
   setup
ok
se bifeaza
   rc.cups
ok  
se da restart

3.setari- periferice - imprimanta - adauga imprimanta clasa - imprimanta locala (paralela, seriala, usb, etc)
-usb printer #1 lexmarc- Z600 next ......
in Slackware a mers

Edited by marin.p, 24 October 2006 - 21:11.